PNA,
Inc. is proud to supply you and our network of dealers with the high quality PENSOTTI
BLUELINE Cast Iron Boiler throughout the North American marketplace.
We
are confident that your purchase of the PENSOTTI home comfort package will
provide years of efficient, economical, trouble-free operation.
"Quality remains long after
the price is forgotten".
The
PENSOTTI BLUELINE boiler is a high efficiency residential heating appliance
that provides maximum energy utilization and the highest efficiency.
Fuel
cost savings can only be achieved by matching the PENSOTTI BLUELINE boiler to
the true heat loss of your residence. During the past couple of decades, the
trend towards improving wall and ceiling insulation levels and eliminating air
infiltration by caulking and weather-stripping, has made most existing heating
appliances oversized.
When
you purchase a PENSOTTI home comfort system your new appliance will be sized on
the basis of the new heat loss calculation. This will ensure that your new
PENSOTTI home comfort system will deliver only the amount of heat required to
match your actual home’s heating demand. We want to provide you with the
maximum comfort level achievable combined with the highest fuel cost savings.
The
following are useful bits of information presented under a series of
sub-headings.
Annual Fuel Utilization Efficiency
(A.F.U.E.)
The
A.F.U.E. is a measure of the estimated ability of a heating appliance to
extract heat from the fuel, based on a full heating season.
The
A.F.U.E. increases as the burner on time increases until it reaches
‘steady-state efficiency’. Steady state is the efficiency of the appliance
measured when the burner is running.
Any
time the burner cycles on and off, the A.F.U.E. drops because of "off-cycle"
losses. The A.F.U.E. drops most sharply when the heating plant operates between
10 and 30% burner on time.
An
increase in the percentage of burner on time improves the A.F.U.E.
A General Comment
The
PENSOTTI BLUELINE boiler is a high quality, efficient oilfired heating
appliance, which must be installed and serviced by a trained and if required
licensed service technician.
Oilfired
installations should be installed in accordance with NFPA31 and NFPA211 when no
local code is in effect. Be sure that the installation is according to all
National, State and local codes and authorities having jurisdiction over
heating, electrical, plumbing and oil burner systems.
The
electrical system to this unit should be supplied by a separate circuit
provided with a fused disconnect switch at the service panel.
All
boiler installations must conform to the A.S.M.E. Boiler Code. If the boiler
requires National Board approval consult PNA, Inc. for special order. Many
states and local authorities require National Board inspection and registration
for installation in buildings used for public assembly, more than four (4)
apartments, etc.
It
is important therefore that these instructions be followed carefully and that a
competent PENSOTTI dealer installs the BLUELINE Series boiler only.
The
boiler should only be used as the primary heating source of a well-designed and
installed hydronic heating.
It
is the responsibility of the installer to ensure that this boiler is installed
properly and that all settings and adjustments are made before putting the unit
into service.
The
boiler is provided with a Lifetime Limited Warranty. A copy of the warranty is
found on the inside front cover.
No comments:
Post a Comment